I print on a glass bed covered with BuildTak. Prints stick well, release is difficult. They sell a mod, self adhesive magnetic sheet that holds a steel plate which in turn you put the BuildTak on making it easier to get your prints off by twisting the flexible steel as opposed to chiseling your print off a glass plate while attempting to not peel chunks of the expensive Buildtak off.

Magnetic sheets have different strengths proportional to thickness in milimeters. I can get 0.03 mm locally which provides 85 lbs pull per sqft. and was wondering if this might work. It's hard to find the stronger pulls, 0.045 mm and 0.06 mm which can pull 115 and 145 lbs respectively.

I'd prefer cut my own new bed sandwich rather than pay 90 bucks for one.

• Has anyone made a bed using adhesive magnetic sheet>


• What thickness magnetic sheet has worked for you?


• What thickness steel are you using?

Assume it has to flex easily to twist the part of and also flexible enough for the magnet to pull it flat.

With respect to the comment by tbm0115:

I don't think you need that much magnetic pull for this application. Adhering basic coin magnets to a material in a large array should secure the material appropriately for a desktop printer.

I see where you are going with coin magnets. Have you tried this? In the original Makerbot Cupcake this is how it was done though with larger build surfaces you get warp on metal plates. Most metal sheet comes from the plant on a roll. Though your metal looks nice and flat, temperature changes will cause it to warp and as you know with SLA printers, a changing bed can cause a failure. This happened on the original Makerbot replicator 1st release followed by using a machined plate as a replacement.