Connecting Anet A8 to PC issue
I am still at calibration stage and need some info from the PCB. I connected the USB and ran Repetier. The PCB wants to talk at a higher baud rate than my serial port says it can do. I tried setting the serial port to its highest setting 125k and reduced the PCB baud in Repetier setting to 125k. No joy. PC port reverts to 9600 every time I check it. Thoughts?
PC running Windows 7 Home Premium 32bit.
Sorted. Repetier Server was hijacking my com port. Uninstalled it and Repetier host worked fine. As I have no desire to monitor or control prints remotely I have no use for the server software.
Hope that helps others.
License under CC-BY-SA with attribution
Content dated before 7/24/2021 11:53 AM
